1. Cold aggregate feeding system
★ The belt is controlled by variable frequency speed governor and can be operated in the operating room, which is convenient and intuitive, providing a better adjusting precision of the operator.
★ Alarm devices are installed at each outlet of the system to inform the material shortage or material blockage in time.
★ Each inlet is equipped with screen mesh to avoid the entry of large size materials into the system, which not only saves fuel, but also effectively prolongs the service life of drying cylinder, hoist and vibrating screen.

2. Aggregate drying system
★ A negative pressure gauge is arranged at the smoke treating part of the drying cylinder, so the combustion system is always in the best condition.
★ Light oil or heavy oil is used as fuel. The dual ignition design makes the combustion stable and full.
★ The friction drive mode is driven by four motors simultaneously, which makes the driving stable and the noise small.
★ The cylinder shell is stainless steel with cotton rock material insulation layer added, which makes it has good oxidation resistance and corrosion resistance.

3. Aggregate screening and metering system
★ Aggregate adopts four-point structure sensor to measure the force, asphalt and powder use three-point structure sensor to measure the force. after the sensor signal processed by the electronic scale and computer, the weighing value will be digitally displayed.
★ The screen is made of high strength manganese steel, with an arch-like cross-section, high in the middle, slightly lower on both sides, which is beneficial to enlarge the contact area of material.
★ The drawer type design makes the screen convenient to replace.
★ The system adopts special structure to make the bearing always immersed in the oil and get sufficient lubrication, which greatly improved the service life of the bearing and reduced the failure rate.

4. Mixing cylinder
★ The liner and blade of the mixing cylinder are chromium alloy castings with high wear resistance, which guarantees the long service life of the mixing cylinder.
★ Asphalt is sprayed by the asphalt pump on the aggregate surface evenly for easy mixing.
★ External oil heater is added to the mixing cylinder to ensure the temperature of special materials, such as modified asphalt, rubber asphalt, hot recycled materials and so on.

★ Two-stage dust removal mode
The first stage adopts a volute dust collector or a cyclone dust collector, which collects large dust grains and sends them to the hot aggregate hoist by a spiral conveyer for reuse.
The second stage adopts a high-pressure pulse bag filter with compartmented chambers, whose high-temperature resistant filter bag is made in the United States. It has good air permeability and a dust removal rate up to 99.5%.

★ Other optional dust removal devices
Dust collecting devices under the mixing cylinder and product bin, dust shield over the conveyor belt. They can further reduce the environmental pollution caused by equipment.