Bus Wash Equipment with Rollover 2 Brushes Manufacturer

Bus Wash Equipment with Rollover 2 Brushes

: http://carwash-system.com/3-1-bus-wash-equipment-with-rollover-2-brushes.html

Bus wash equipment with 2 rollover brushes are used to clean two sides, the head, and back side of busses. This bus wash system is ideal for washing vehicles where the length does not exceed 18,000mm, the height does not exceed 4,200mm, and the width is 2,700mm. This system is capable of washing up to 15 buses per hour. During the washing process, the bus remains motionless, and the machine will move the brushes over and around the vehicle. Shown below are some basic parameters.

Parameters

Model	CB-720
Dimension	LWH: 2880mm×5120mm×5900mm
Assembling Range	L≤24000mm×W 6800mm
Moving Range	L 1800-2400mm × W 6800mm
Voltage	AC three-phase four-wire system Voltage AC380V50Hz
Water Supply	DN25mm water flow rate≥120L/min
Ground Flatness	Deviation≤10mm
Washing method	1 rollover
Applicable Vehicles	Container truck, box truck, bus
Applicable Car Dimension	L≤18000mm×W 2700mm×H≤4200mm
Washing Time	12-15 cars/h

Advantages

The fully automatic PLC electronic control system improves the security.
A one-click washing method simplifies operation.
The galvanized bus wash system frame is corrosion resistant.
There is no need for extra wiping after the washing process.

Configurations

Standard Devices

Frame

Brush system

Lateral brush motor

Drive motor

Water pump

Equipment data intellectualization

Self-diagnose system